EUROM Q-time 1500 Manuel D'utilisation page 19

 Only connect the heater to an earthed socket! For personal protection the installation,
to which the Q-time 1500 is connected, has to be equipped with an earth fall device
(max. 30 mAmp).
Permanent mounting:
The Q-TIME 1500 is designed for installation in a permanent position and direct connec-
tion to the electricity network. For safety reasons, this installation should be fitted by an
approved electrician.
Plug connection:
The Q-TIME 1500 can also be connected directly to a power socket using the electric ca-
ble and plug. Make sure that the electric cable does not hang over any (sharp) edges,
does not make any sharp angles, cannot be dragged and does not touch any hot surfaces.
Important: the electric cable and plug form a whole. Therefore, if either the electric cable
or plug is damaged they should both be replaced by an electrician. Only mount the original
parts!
 When positioning and connecting the heater, make sure that your hands do not touch
the heating elements. This is because traces can be left behind which, afterwards, will
have a negative effect on the radiated heat.
 For use with a plug, the following applies: do not use extension leads and do not con-
nect any other equipment next to the heater in the same socket!
 Position the mounting bracket with the long side and 2 holes against the wall in the re-
quired position, then mark the drill holes. Make sure that the drill holes are positioned at
the same height! Remove the bracket and drill 2 holes in the spots marked. Knock in the
raw plugs, position the bracket over the top and screw it firmly into the wall using the
screws supplied.
 Place the heater over the bracket with the cord down and large holes positioned over
large holes. Screw securely using the bolts, rings and nuts supplied (1).
 Turn the heater to the required position. The
body of the heater can be turned to 5 positions
(small heater holes (3) over small bracket
holes (2)). The mid position is horizontal to the
room. The two positions which are directed
upwards will only be used in exceptional cases
and require a greater distance to the ceiling (2
metre). Finally, the heater has two positions
which are directed downwards. These are the
standard positions. Secure the heater at the
required angle by screwing both of the small
screws into the double holes.
 The heater is now ready for use.
The Q-TIME 1500 is supplied with a turn-knob with ring and spring washer. This allows the
Q-time to be fitted on an appropriate stand. Only choose a firm stand and ensure that the
stand is stable on a perfectly flat and level surface! The draw-cord control exerts force on
the device; it may therefore not become unbalanced! All other safety regulations also fully
apply for the design of the stand.
19