EUROM Q-time 1500 Manuel D'utilisation page 16

en er geen meubels op worden gezet. Leid de kabel niet om
scherpe hoeken en wind hem na gebruik niet te strak op!
 Immediately lead the cable out of the heater's range and prevent
it from becoming hot.
 Don't locate the appliance just above or below a wall socket.
 Keep all flammable things as furniture, curtains, paper etc. away
from the appliance (at least 1 meter).
 Despite of the fact that the Q-TIME 1500 is splash proof, you
have to be careful with water. Make sure that the Q-TIME 1500
cannot fall into water and don't expose it to heavy water beams.
Don't touch it with wet hands. The heater is to be installed so that
switches and other controls cannot be touched or operated from
the pool, bath or shower.
 In order to avoid overheating and fire hazard, do not cover or ob-
struct the appliance. Do not put any of the following materials on
the appliance, such as clothes, blanket, pillow, paper etc. The
minimum distance 1 meter between the appliance and flammable
materials must always be maintained.
 Be carefull! Some parts of this product can become very hot and
cause burns. Particular attention has to be given where children
and vulnerable people are present. do not let bare skin come into
contact with hot surfaces. Pay attention that no combustible mate-
rials (such as curtains, marquees, flags, plastic foil etc.) due to
wind or other environmental influences come to close to the ap-
pliance. That can cause singe damage or fire. Pay attention that
they don't cover or obstruct the appliance. That can cause dama-
ge or fire!
 Make sure that the cord not hangs over (sharp) edges, not makes
strong curves, not can be pulled along and not touches hot sur-
faces.
 Do not adjust the heater's direction of radiation whilst it is on, but
switch the heater off and allow it to cool down first of all.
 If the appliance, by whatever which reason, produces cracks or
breaks, if you during the operation establish imperfection or inter-
ruption, or if the aluminium casing, the front cover surface or the
cord or plug show flaws, discontinue the operation of the appli-
ance and take the plug from the socket.
 If the appliance, the cord or the plug is damaged or shows imper-
fection, contact your supplier, the manufacturer or a qualified ser-
vice point. Do not try to repair the appliance by yourself, to avoid
16