Adjusting The Chain Tension - Sherco TY 12S Manuel Du Propriétaire

Adjusting the chain tension

A
B
C
D
The chain must be given special attention because
the life of the sprocket assembly, crown wheel and
the chain itself depends on its good maintenance.
The area
the tensioner, as shown in the image.
WARNING
The vertical play of the chain in the area where the
tensioner acts should be between 10 and 15 mm
To make the adjustment:
- Loosen the nut
the wheel.
- Turn the 2 eccentric adjusters
trically until the proper chain tension is obtained.
WARNING
Place the motorcycle in an upright position and
immobilise it at the front.
E
WARNING
The position of the two eccentric adjusters should
be symmetrical to ensure proper alignment between
the wheel sprocket and the drive sprocket.
WARNING
Check the condition and tension of the chain tension
and its greasing regularly. See Maintenance table.
for checking the chain tension is next to
A
and the wheel shaft
B
.
A
from
E
and symme-
C D
65 65