Seca 334 Mode D'emploi page 8

Operation
Weighing correctly
– Press the Start key with no load on the
scale.
se(A 88888.
, and
consecutively in the display. The scale is then
automatically set to zero and ready for
operation.
– Place the baby on the scale.
– Read the weight off the digital display.
Weight is displayed in 5 g increments up to
10 kg and in 10 g increments up to 20 kg.
Pressing the START key again switches off
the scale.
Auto hold function
For weights above 0.4 kg, the HOLD function
is activated automatically. The display flashes
until a stable weight has been measured. The
8
display is then frozen until the next weighing
operation takes place. HOLD appears in the
display.
Automatic shut-down/power-saving
mode
0. 0 00
appear
To save power, the scale switches itself off
after a short time if there is no load on it.
Switching the weight display
Switch on the scale. Weight is initially
displayed in the last setting used, either in
kilogrammes or pounds.
To switch the weight display between
kilogrammes and pounds, press the kg/lbs
key.
Taring weight display (TARE)
The tare function is useful if an additional
weight (for example a cloth or pad on the
weighing surface) is to be ignored in the
weighing result. Proceed as follows:
press the TARE key while the additional
weight is on the scale and wait until
appears in the display.
Important!
The maximum weight which can be displayed
is reduced by the weight of the objects
already placed on the scale.
You can now perform as many weighing
operations as you like with this additional
weight.
You can switch off TARE by pressing the
TARE key again or by switching off the scale.
Use of differential display function
You can use this function for example to
measure the intake
breastfeeding or have Baby's increase in
weight displayed since being last weighed.
This function can be used to store an
individual weight value and then use that value
to form a difference - to detect the amount of
milk ingested during breastfeeding, for
example, or to see how a particular baby's
weight has increased since it was last
weighed.
– To store the weight value, press the
STORE key for approx. 2 seconds after
the weighing operation is complete. The
ST0
indicator is faded in. The weight val-
ue is now saved and will also remain
stored once the scale is switched off.
– With a subsequent weighing operation it
is then possible to switch the display
over to differential display, i.e. display of
current value less saved value, by briefly
pressing the STORE button.
0. 0 00
When the differential display function is
activated, appears in the display.
– Briefly pressing the key again switches
the function off again.
Note:
If a new weight value is stored, the previous
stored value will be overwritten.
If the differential display function is activated
with no load on the scale, the stored value is
shown in the display as a negative value.
of milk when