IBEA IB 562 Manuel D'instructions page 58

C) BRAKE ADJUSTMENT
To adjust the brake cables place the machine on a flat surface, switch off the engine and
disconnedct the spark plug wire.
C1) BLADE ROTOR CONTROL
Remove the plastic guard (Fig 8 rif C), by undoing and removing the fixing screws using the
wrench illustrated in fig 8 rif. D. Remove the pin that secures the fork.
To make an optimum adjustment :
screwing or unscrewing the fork you can decrease the distance between the brake and the pulley
rotor.
Figure 6
C2) FORWARD BRAKE
If the forward lever is released the machine fails to halt instanttly the brake must be regulated:
- using the brake adjuster located on the handlebar (fig 5 pos.C)
- using the brake cable clamp ( fig 7 pos. A)
If the operation proves ineffective proceed as follow:
- loose the M10 nut (fig. 7 pos. B)
- turn the nut until a distance of 1 mm between eccentric and brake
Figure 7
- 58 -