Charging The Battery Pack; Viewing Images On A Tv Screen - Sony CSS-SA Mode D'emploi

Charging the battery
pack
Place the camera with the battery pack
inserted on the Cyber-shot Station.
Charging starts automatically. The CHARGE
lamps of the Cyber-shot Station light up.
Battery level: LOW
Battery level: MIDDLE
Battery level: HIGH
• The light starts coming on from the left.
• It might take a few seconds for showing an
accurate battery level.
• The battery level will be displayed in three
levels on the CHARGE lamps of the Cyber-
shot Station while charging the battery pack.
When charging is completed, the CHARGE
lamps go off.
– When charging the battery pack, make
sure the camera is turned off.
– You cannot charge incompatible
battery packs. Charge only the
compatible battery pack NP-NH25.
• The charging time for a battery pack NP-
NH25 is approximately 3.5 hours.
• When the CHARGE lamps fail to light, or
when they blink, refer to "Troubleshooting."
10-GB
Viewing images on a TV
screen
1
Connect the A/V connecting cable
(supplied) to the A/V OUT (MONO) jack
of the Cyber-shot Station and the audio/
video input jacks of the TV.
A/V connecting cable
If your TV provides stereo input jacks,
connect the audio plug (black) of the A/V
connecting cable to the left audio jack.
– Turn off both camera and TV before
connecting the Cyber-shot Station and
the TV by the A/V connecting cable.
2
Set the DISPLAY SELECT switch to "TV."
3
Set the mode dial of the camera to
and turn on the power.
4
Turn on the TV and set the TV/Video
switch to "Video."
5
Press / on the Control buttons to
select the desired image.
– You can also select the image by
pressing /
the camera.
– The Cyber-shot Station is compatible
with both NTSC and PAL TV systems.
For further details, see the operating
instructions supplied with the camera.
on the Control buttons of
,