Operating Instructions - Skil PWRCORE 12 AH6552A-00 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them . Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc., can cause a short
circuit.
WARNING
could result in serious personal injury.
WARNING
is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
parts, making adjustments, cleaning, or performing maintenance . This cordless auto
hammer must be used only with the battery packs and chargers listed below:
2Ah
SKIL BY500101
SKIL BY519901
NOTICE: Please refer to the battery and charger manual for detailed operating information.
To Attach/Detach Battery Pack
(Fig.2)
Avoid the possibility of accidental starting:
Set the trigger lock in the locked position before
attaching or detaching the battery pack. See
the detailed instructions in the section "Trigger
Switch and Trigger Lock".
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves in the tool, and then slide the battery
pack onto the tool.
To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and remove it from the tool.
NOTICE: When placing the battery pack on the tool, be sure that the raised rib on the battery
pack aligns with the groove inside the tool and that the latches snap into place properly.
Improper attachment of the battery pack can cause damage to internal components.
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced . Use of this product with damaged or missing parts
Do not attempt to modify this tool or create accessories not
recommended for use with this tool . Any such alteration or modification
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling
Battery Pack
SKIL BY519801
4Ah
Fig . 2
Attach
Battery-release
Button
Charger
SKIL QC535701
SKIL SC536501
Detach
11