Operating Instructions - Skil PWRCORE 20 Guide D'utilisation

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc, can cause a short
circuit.
WARNING
parts could result in serious personal injury.
WARNING
modification is misuse and could result in a hazardous condition leading to possible serious
injury.
WARNING
parts.
This cordless multi-tool must be used only with the battery packs and chargers listed below:
2Ah
SKIL BY519701
SKIL BY519702
NOTICE: Please refer to the charger and battery manual for detailed operating information.
To Attach/Detach Battery Pack (Fig .2)
Make sure that the ON/OFF switch is in the "OFF" position when attaching or detaching the
battery pack.
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves of the tool, and then slide the battery
pack onto the tool.
NOTICE: Make sure that the latch on the
battery pack snaps into place and that the
battery pack is secured to the tool before
beginning operation.
To detach the battery pack:
Depress the battery-release button located
on the front of the battery pack to release the
battery pack. Pull the battery pack out and
remove it from the tool.
NOTICE: When placing the battery pack on
the tool, be sure that the raised rib on battery pack aligns with the groove inside the tool and
that the latches snap into place properly. Improper attachment of the battery pack can cause
damage to internal components.
WARNING
carrying at your side .
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack or charger in
If any parts are damaged or missing do not operate this product until
the parts are replaced . Use of this product with damaged or missing
Do not attempt to modify this multi-tool or create accessories not
recommended for use with this multi-tool . Any such alteration or
To prevent accidental starting that could cause serious personal injury,
always remove the battery pack from the multi-tool when assembling
Battery Pack
2.5Ah
SKIL BY519703
Battery tools are always in operating condition . Therefore, the ON/
OFF switch should always be in OFF position when not in use or
4Ah
SKIL BY519601 SKIL BY519603
Fig. 2
Attach
Charger
5Ah
SKIL SC535801
SKIL QC536001
Detach
Battery-release
Button
11