Skil PWRCORE 12 AH6552A-00 Guide D'utilisation page 14

5. Holding the shaft of the nail steady with your hand, push down on the tool and press the
trigger switch to initiate the hammering action and drive the nail deep enough into the
workpiece so that it stands on its own. Release the trigger switch and remove your hand
from the nail.
WARNING
6. Resume pushing down on tool and pressing the trigger switch to continue hammering until
the nail is fully driven into the workpiece. Near the end of hammering, the magnetic sleeve
will retract to allow the hammer-head to drive the nail head flush into the workpiece.
WARNING
hammer-head to drive the nail automatically.
Recommended Nailing Materials for the Auto Hammer
The auto hammer may be used for nailing into all types of wood, wood-like materials, and
plaster board.
NOTICE:
The tool is not suitable for nailing in hard metal or concrete.
14
Be especially careful when driving shorter nails, such as brads, and remove
your hand as soon as the nail stands on its own in the workpiece.
To avoid possible serious injury, do not overly force the hammer or apply
side pressure. Hold the tool firmly while pushing steadily to allow the