Sanremo CAPRI XLC SAP Livret D'instructions page 24

ENGLISH
To enable pre-brewing
With the appliance switched off, put the on/off switch (D) to position 1 and at the same time keep the button (M1) on the left-hand group pressed until the
indicator light corresponding to the button (M5) remains lit; then release the button (M1). Now put the on/off switch (D) to position 0 and then to position
2 in order to store the operation.
To disable pre-brewing
With the appliance switched off, put the on/off switch (D) to position 1 and at the same time keep the button (M2) on the left-hand group pressed until the
indicator light corresponding to the button (M5) remains lit; then release the button (M2). Now switch the appliance off and then on again using the on/off
switch (D) in order to store the operation.
CLEANING
Filter:
after having dispensed the last cup of coffee, the fi lter and fi lter holder must be washed with water. If they are damaged, worn or clogged, they
should be replaced.
Drip tray and grid:
the drip tray and grid should be removed frequently and coffee residues cleaned away.
Water softener:
the softener should be periodically regenerated according to the manufacturer's directions given in the instruction booklet.
External housing:
the external housing and the steel parts should be cleaned with sponges and soft cloths to avoid scratching. Only use
detergents that do not contain abrasive powders or solvents and do not use steel wool.
WARNINGS:
when using the appliance it is recommended that the various instruments be kept under control, checking that they are in the
previously indicated normal working conditions.
When the appliance has been left unused for a number of days, or every 2/3 months during normal use, to clean the internal circuits more effi ciently, it is
good practice to fi ll the boiler a number of times and deliver simple water and coffee to be thrown away.
APPLIANCE FAILURE
The user must check that this is not due to:
- power failure or blackout.
- lack of mains water supply or no water inside the boiler.
For any other causes, contact a qualifi ed SANREMO After-Sales Service Centre.
BEFORE CARRYING OUT ANY WORK INSIDE THE APPLIANCE OR REMOVING ANY PART OF THE HOUSING, ALWAYS DISCONNECT FROM THE
ELECTRICITY SUPPLY.
WARRANTY
Every purchased appliance (keep the receipt, invoice and delivery note) is covered by a statutory guarantee. This warranty envisages the replacement free
of charge of parts that are shown to the service centre or manufacturer's satisfaction to be defective due to faulty materials or workmanship and providing
that the appliance has not been misused or tampered with by unauthorised persons or persons using incorrect components or techniques.
Any defective part shall be returned to the manufacturer.
NOTE: never activate the pump without water. Excessive heat will damage the pump and no warranty replacement is granted in that case.
WARNINGS
The appliance must not be cleaned using a water jet.
Do not put the appliance in water.
The appliance must not be positioned near to any source of heat.
The appliance is unsuitable for outdoor installation.
To ensure safe use the appliance must be in a level position.
If the power cable is damaged, have it replaced by a SANREMO After-Sales Service Centre, since a special tool is required for this purpose.
The appliance must be used in rooms with a temperature between 5°C and 35°C.
IN THE EVENT OF FAILURE OR MALFUNCTION, REQUEST SERVICE ONLY FROM QUALIFIED PERSONNEL AT THE AFTER-SALES SERVICE CENTRE.
The data and features indicated in this booklet are not binding on the manufacturer, which reserves the right to make changes to its models at any time.
The manufacturer shall not be under any liability for injury to persons or damage to property arising from failure to comply with the instructions given in
this booklet.
24