Toto Lloyd TL930DDLQ Manuel D'installation Et D'utilisation page 4

1. Remove the T-connector, nuts, and washers
from the spout body.
2. Place the spout through the center hole.
3. Re-assemble the nuts, T-adapter, and
washers in reverse order. Carefully align the
valve shank and hole.
NOTE: When screwing in the T-connector, be
careful not to damage the O-ring.
4. Tighten the shank nut with wrench.
5. Disassemble the handle assembly and
canopy by loosening the set screws located
under the handle and behind the canopy.
6. Remove the top nut.
7. Install the valve body from below through
the hole.
8. Use the template to make sure the valve
height from the top of the mounting
surface is correct. Adjust the top nut
accordingly to set the correct height.
9. Tighten the bottom nut to secure the
valve body.
10. Re-assemble the canopy and handle.
NOTE: Secure the handle onto the valve
stem first.
12. Tighten the canopy with set screw.
INSTALLATION PROCEDURE
4
Shank
Washers
Nut
T-connector
Set screw
Top nut
Valve body
Handle
Bottom nut
Spout body
Set screw