Declaration Of Conformity - Holmatro SMV Mode D'emploi

1.5.3 Double Manifold Valve (DMV)
Double-acting manifold valves are intended to be used with double-acting tools.
1.5.4 Holmatro Manifold Single (HMS)
The Holmatro manifold single-acting is intended to be used with single-acting tools, the needle valves of
the HMS allow for highly accurate adjustment of the oil flow.
1.5.5 Holmatro Manifold Double (HMD)
The Holmatro manifold double-acting is intended to be used with double-acting tools, the needle valves
of the HMD allow for highly accurate adjustment of the oil flow.
1.5.6 Workability
The workability and life span of the product strongly depend on a number of circumstances. Usage
intensity and the applied pressures are examples of these circumstances. When in doubt about the
workability or life span of this product, contact Holmatro in any event.
1.5.7 System requirements
Because of the diversity in control, operating pressure and required oil volume per tool, not all
combinations of Holmatro pumps, hoses and tools can be applied. In case of doubt about the
compatibility of the system, always consult the Holmatro dealer.
1.6 Qualified personnel
The system may only be operated by people trained in its use. Always obey local legislation, safety and
environmental regulations. Repair work may only be performed by a Holmatro Certified Technician.
1.7 Guarantee
Refer to the general terms and conditions of sale for the guarantee conditions.
Holmatro draws your attention to the fact that every guarantee on your piece of equipment or system
will lapse and that you must indemnify Holmatro against any possible product liability and responsibility
if:
• service and maintenance are not carried out strictly in accordance with the instructions, repairs are
not performed by a Holmatro Certified Technician or are performed without prior written consent;
• self-made changes, structural changes, deactivation of safety devices, injudicious adjustment of
hydraulic valves and faulty repairs have been carried out;
• non-genuine Holmatro parts or lubricants other than the types prescribed are used;
• the piece of equipment or the system is used injudiciously, through errors of operation, improperly,
negligently or not in accordance with its nature and/or purpose.
1.8

Declaration of Conformity

The equipment is CE certified. It means that the equipment complies with the essential requirements
concerning safety. The original Declaration of Conformity is supplied with the equipment.
The standards and directives that have been taken into consideration in the design are listed in
section Technical Specifications in this document.
S/DMV + HMS/D 916.000.874_003
EN
19