Programming.the.remote.control - Becker Centronic SensorControl SC811 Notice D'utilisation

Programming the remote control
Note
Before the SC811 can be programmed, a master transmitter (e.g.
SWC441) has to be programmed into the radio receiver for sun protec-
tion systems, and the limit stops have to be programmed.
Caution
Before programming the master transmitter, always ensure that there
are no obstructions in the immediate operating area of the sun protec-
tion system, as the system may extend unexpectedly.
Programming the SC811
The.SC811.features.an.integrated.radio.transmitter.
a).Press.the.programming.pushbutton.of.the.master.transmitter.until.acknowl-
edgement.is.given.by.the.receiver.
b).Press.the.programming.pushbutton.on.the.SC811.until.the.receiver.confirms.
the.signal.setting.
c).Now.press.the.programming.pushbutton.on.the.new.SC811.to.be.programmed.
once.more.
The.receiver.will.indicate.when.the.learn.process.has.been.successfully.com-
pleted.
The.maximum.radio.range.is.up.to.5.m.indoors.and.up.to.350.m.in.the.open..
DE
GB
FR
NL
15