Peg-Perego Viaggio 2-3 SHUTTLE Plus Notice D'emploi page 28

on the back of the headrest and
simultaneously raise the headrest
(fig_b), placing it at the desired height.
IMPORTANT: as the child grows,
it is necessary to adjust the height
of the headrest according to that of
the child.
IMPORTANT: after completing
the operation, try moving the
headrest to ensure it is correctly
fitted in place.
4• The width of the backrest may be
adjusted in three positions (closed, mid,
opened). Push the button on the side
of the knob (1) and rotate the knob
(2) clockwise to open the wings. This
operation is required as your child grows.
To close the wings, push the side button
and turn the knob anti-clockwise.
5• The height of the backrest can
be adjusted in 3 positions: push the
handle behind the backrest upwards
(1) while simultaneously raising the
entire backrest (2) to the desired
position. To lower the backrest, pull
the handle (1) and at the same time
push the backrest downwards (2). This
operation is required as your child
grows.
How to attach the car seat
to the vehicle
if you own a car with
Isofix attachments
This type of attachment can be used
if your car is fitted with Isofix hooks.
Otherwise, go to the next section. For
further information on the availability
of these hooks and their location, refer
to the vehicle's instruction manual.
Fastening
guarantees greater stability and
safety in the vehicle, but cannot
replace the restraining function of
the vehicle's seat belts.
6• To lengthen the connectors inside of
the seat, turn the handle on the front
of the seat, placing your hand into the
slot shown in yellow (fig_a) pulling
it longitudinally towards you (fig_b).
The connectors will automatically be
expelled (fig_c). Repeat to ensure that
the connectors have been expelled at
the same time and are extended fully.
7• Fix the connectors of the car seat
to the Isofix hooks in the car itself,
verifying that they "click" into place.
8• IMPORTANT: The vehicle's
Isofix hooks and the seat are correct
coupled when a green signal appears
above the connectors (fig_a). A red
signal indicates that the attachments
have NOT been coupled correctly
(fig_b).
9• The car seat may be reclined as
shown in the figure.
Lengthen the Isofix connectors by
pulling the car seat towards you to
recline the seat.
10• To release Viaggio 2-3 Shuttle
Plus from the seat, pull the handle (1)
until the connectors are completely
exposed. By doing this, the yellow
release buttons will be visible on the
sides of the base; pull the two buttons
(2) until you hear the click of the
connectors opening.
- 28 -
the attachments
You can the