SilverCrest SHBS 3.7 B1 Mode D'emploi page 20

Masquer les pouces Voir aussi pour SHBS 3.7 B1:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

__NAS281952_Haar_und_Bartschneider_5in1_B6.book Seite 18 Dienstag, 11. Oktober 2016 4:10 16
3. Apply a few drops of blade oil 16 to the cutting edge
of the attachment. Using a soft cloth, wipe off the sur-
plus oil, if necessary. Only use acid-free oil, such as
e.g. sewing machine oil.
Nose/ear hair trimmer attachment
• Remove the nose/ear hair trimmer attachment 12.
Rinse it with water and let it dry completely before us-
ing it again.
Shaving attachment
WARNING!
Do not detach the shaving foil from the shaving foil frame,
and do not clean it using the cleaning brush 17.
NOTE: from time to time, oil the cutting blade with a few
drops of acid-free oil (e.g. sewing machine oil). Attach the
shaving attachment to the hair and beard trimmer 5 and let
it run for a few seconds without using it. Using a soft cloth,
wipe off the surplus oil, if necessary.
1. Remove the shaving attachment 3.
2. Press the button on the side of the shaving attachment
and remove the shaving foil frame. While removing
the shaving foil frame, only hold it at the side and do
not press against the shaving foil.
3. Clean the cutting blade using the included cleaning
brush 17.
4. Clean the shaving foil in the shaving foil frame under
running water and allow it to dry completely before
putting it back on the shaving attachment 3.
18
GB
3
12

Publicité

Table des Matières
loading

Table des Matières