Operation; Transport Safety Lock; Changing The Cutting Attachments - SilverCrest SHBS 3.7 B1 Mode D'emploi

__NAS281952_Haar_und_Bartschneider_5in1_B6.book Seite 12 Dienstag, 11. Oktober 2016 4:10 16

6. Operation

Regardless of the charging state of the battery, the 5in1 hair
and beard trimmer can always be mains-operated.
1. For mains operation, ensure that the hair and beard
trimmer 5 is switched off.
2. Connect the power unit 10 to the connector of the
hair and beard trimmer 5.
3. Insert the power unit 10 into a readily accessible wall
socket whose voltage matches the voltage stated on
the rating plate.
4. Switch on the device with the on/off switch 7.

6.1 Transport safety lock

When the transport safety lock is activated, the battery sym-
bol 8 flashes green 3 times.
• Press and hold the on/off switch 7 for approx. 3 sec-
onds to activate/deactivate the transport safety lock.
• By connecting the power unit 10, the transport safety
lock is deactivated, and also cannot be activated while
plugged in to the power supply.

6.2 Changing the cutting attachments

WARNING! Risk of injury!
Switch off the hair and beard trimmer 5, before you attach
or remove the attachments.
• Figure A: to remove the attachments 13, 3, 4, 12,
14 use your thumbs to press the attachment towards
the rear of the hair and beard trimmer 5.
12
GB