Hatco Thermo-Finisher TFWM Série Manuel D'installation Et D'utilisation page 9

English
Installing TFWM36-3900 and TFWM36-3939 Models
Use the following procedure to mount a TFWM36-3900 or
TFWM36-3939 wall mounted food finisher on a wall.
Parts Included
The following parts are included with wall mounted units.
Item
Wall Bracket
1/4" (6 mm) x 2-1/2" (64 mm)
Lag Screw
Bottom Channel
Bottom Channel Screw
Installation Procedure
1. Make sure the mounting location meets the requirements
listed previously in this procedure.
2. Determine the height for the unit installation.
a. Mark the wall at the desired height for the top of the cabinet.
NOTE: The top row of holes on the wall bracket is approximately
one inch below the top of the unit after installation.
3. Locate the stud positions in the wall.
a. Determine which studs to use for installation. The
studs used must allow the wall bracket to be installed a
distance of 16" (406 mm) on center from each other.
NOTE: The wall bracket is shipped upside down and hanging
on the 1/2" (13 mm) hanging rods on the back of the
unit. Make sure to rotate the wall bracket 180° before
marking the locations for the lag screws and installing
the brackets. The smooth, flat side of the wall bracket
should be installed against the wall.
4. Install the wall bracket onto the wall.
a. Center and level the wall bracket hole patterns on center
of studs. Mark the locations for four vertically-spaced lag
screws through the holes on each side of the bracket.
b. Drill eight 3/16" (5 mm) pilot holes in the wall at each
marked location for the lag screws. The lag screws are
1/4" (6 mm) in diameter and 2-1/2" (64 mm) long.
c. Insert eight lag screws through the wall bracket and into
the pre-drilled pilot holes in the wall.
d. Tighten each lag screw securely.
1/2" (13 mm)
Sheathing
Lag
Screw
16" (406 mm) On Center
Attaching the Wall Bracket (TFWM36 Series)
Form No. TFWMM-0817
Quantity
1
8
1
3
3/16" (5 mm)
Pilot Holes
Wall
Bracket
2x4 Studs
5. Lift the unit and hook the upper and lower 1/2" (13 mm)
hanging rods on the back of the unit over the corresponding
hooks on the wall brackets. Make sure the unit hanging
rods are fully seated in the wall brackets. This step will
require several people.
6. Attach the bottom channel to the bottom of the unit.
a. Position the bottom channel into the gap between the
wall and the back of the unit.
b. Align the holes on the back of the unit with the holes on
the bottom channel.
c. Thread the bottom channel screws through the flange
under the unit and into the bottom channel. Tighten
securely.
NOTE: Installation of the bottom channel will prevent the unit
from lifting up off the wall bracket.
No combustible surfaces
No surfaces
within 3"
(76 mm).
Bottom Channel
Screw
Hanging the Food Finisher (TFWM36 Series)
9
INSTALLATION
within 40" (1016 mm).
No surfaces
within 3"
(76 mm).
Bottom
Channel