Remote Controller; Cameras; Power Supply Units; Accessories - Monacor Security DVT-440SET Mode D'emploi

8 Button AV to switch over between the picture
reproduction via the screen (4) or via a monitor
connected to the jack AV OUT (3) – also see
item 3
9 TALK button: Keep the button pressed for an
announcement via the speaker of the selected
camera
10 Buttons and
1. when no menu is activated: To select the four
camera channels and the quad picture with
all camera channels
2. when a recording is replayed: To adjust the
volume
3. when a photo is shown: To go forward to the
next photo or back to the previous photo
4. when a submenu is activated: To select a
menu item or to adjust a value
5. when the zoom function is switched on: To
move the picture cutout
11 Button ENTER
(marked on the remote controller with
To activate a selected submenu and to confirm
an adjustment
When a recording is replayed: To switch be -
tween replay and pause
12 Buttons and
1. When one of the four camera pictures is
shown: To adjust the volume
2. When the main menu is activated: To select a
submenu
3. When a menu item is selected: To change an
adjustment or to select an adjusting possibil-
ity
4. When a recording is replayed: To activate the
fast forward or reverse
5. When the zoom function is switched on:
To move the picture cutout
13 Button REC to take a photo or to start or to stop
a video recording
14 Button MENU
1. to activate the main menu
2. to deactivate the main menu
3. to go from a submenu to one level higher
15 Sound opening for the microphone
16 Slot for an SD / SDHC memory card
17 Mini USB port, only used for software updates

1.2 Remote controller

The buttons of the remote controller (8, 10 – 14)
have the same functions as the buttons on the
monitor and are described in chapter 1.1. The but-
ton (11) is marked ENTER on the monitor but the
function is the same.
1.3 Cameras (rear side)
18 Antenna
19 Sound opening for the microphone
20 Sound openings for the speaker
21 Threaded jack for the camera support
22 SMA jack for the antenna
23 Button "Pairing" to assign the camera to one of
the four camera channels (see chapter 4.2)
24 Inline jack for connection of one of the smaller

power supply units (25)

1.4 Power supply units
)
25 Small power supply unit (4 pieces) for the cam-
eras
26 Power supply unit for the monitor
1.5 Accessories not shown
– base / wall support for the monitor
– supports for the cameras
– connection cable for the AV output (3)
– mounting dowels and screws
GB
15