Binding Cables; Removing The Handles; Affixing The Protection Covers - Sharp PN-V601A Manuel D'installation

Binding Cables

: Cable clamp attachment

Removing the Handles

Handle spacers
Handle screws
Handle
Handle spacers

Affixing the Protection Covers

Protection
cover
Protection cover
The cables connected to the terminals on the rear of the
monitor can be fastened with the cable clamps.
Insert the cable clamp into the cable clamp attachment on the
rear of the monitor and fasten the cables.
Cable
Cable clamp
attachment
Cable clamp
The handles can be removed.
The removed handles can be attached on the side.
1. Remove the handle screws and remove the handles and
handle spacers.
2. Pass the handle screws through the handles and handle
spacers in order and secure.
Caution
• The handles, handle screws and handle spacers are for
this monitor. Do not use them for any other devices.
• When attaching the handles, always use this monitor's
handles, handle spacers, and handle screws.
• Be sure the handles are attached securely.
TIPS
• To lower the height of the handles, attach the handles with
the handle spacers removed. To attach the handles with
the handle spacers removed, secure the handles with the
included handle screws (short).
After installing the monitor, affix the protection covers (4
pieces) as necessary.
11
E