Preparation Of The Place Of Installation; Safety Precautions; Flues And Chimney Cowls - Palazzetti Ecoforno Glass Notice D'installation

5 PREPARATION OF THE PLACE
OF INSTALLATION
5.1

SAFETY PRECAUTIONS

Responsibility for the works carried out in the space of
the Ecoforno location is, and remains, the responsibility
of the user; the latter is also responsible for carrying out
checks regarding the proposed installation solutions.
Any finish in combustible material must be adequately
insulated (and in any case placed outside the irradiation
zone of the Ecoforno).
The user must comply with all the local, national and
European safety regulations.
Check that the total weight of the two appliances
(Ecoforno and Ecopalex T Glass) plus the optional kit is
adequate for the floor capacity on which these devices
will be installed.
If the floor is not of sufficient load-bearing capacity, it is
advisable to use a load distribution plate of adequate
dimensions.
The assembly and dismantling operations of the Ecoforno
are reserved for specialist technicians only.
Users should always use our assistance service for
requests for qualified technicians.
In the case other technicians are involved, it is
recommended to verify their actual abilities.
5.2

FLUES AND CHIMNEY COWLS

For the construction of the flue to be connected to the
Ecoforno, refer to the use, installation and maintenance
manual of the Ecopalex T Glass and to the UNI 10683
standard
18