Manual Adjustment; Electronic Adjustment - Atag VA5511BT Notice D'utilisation

22

Manual adjustment

Electronic adjustment

1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'SETTING
AND STARTING A PROGRAMME'.
2. Press and hold buttons (4) and (5) at the
same time until the indicators of buttons
(3), (4) and (5) flash.
3. Press button (3).
• The indicators of buttons (4) and (5)
go off.
Filling the salt container
Turn the water hardness dial to the position
1 or 2.
• The indicator of button (3) continues
to flash.
• The acoustic signals operate, e.g. five
intermittent acoustic signals = level 5.
• The display shows the setting of the
water softener, e.g.
4. Press button (3) again and again to
change the setting.
5. Deactivate the appliance to confirm the
setting.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt container
(only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the
salt container.
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after
you fill the salt container, start a pro-
gramme.
= level 5.