Cleaning The Spray Arms; External Cleaning; Troubleshooting - Atag VA5511BT Notice D'utilisation

26

Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.

External cleaning

Clean the appliance with a moist soft cloth.

TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with wa-
ter.
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
2. To disassemble the filter (A), pull apart
3. Remove the filter (B).
A1
4. Wash the filters with water.
5. Put the filter (B) to its initial position.
A2
6. Assemble the filter (A) and put it into
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
•
•
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is not a damaged fuse in the fuse
box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the
end of the countdown.
Make sure that the water tap is open.
(A1) and (A2).
Make sure that it assembles correctly
under the two guides (C).
position in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters can
cause bad washing results and dam-
age to the appliance.
- The appliance does not drain the
water.
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Possible solution