3.3
Calling another subscriber
When you want to talk to other subscribers, proceed as follows: The
two radios must be switched on and set to the same channel.
To speak, press the PUSH TO TALK button on the left-hand side.
Hold the unit about 5 cm from your mouth and speak in a normal
voice. When you have finished, release the PUSH TO TALK button.
The person you are speaking to will hear a signal tone (Roger beep)
when you release the TALK button. This will indicate to the other
subscriber that you have finished speaking and are waiting for a reply.
Note: While you are holding the PUSH TO TALK button, you
will not be able to hear any incoming calls. As is usual with
radio units, only one of the two participants in the call can
speak at any one time.
Therefore, always wait until you hear the signal tone (Roger beep)
before pressing the PUSH TO TALK button again.
While you are pressing the PUSH TO TALK button, the
will appear in the display. When you receive a call, the
appear in the display.
Volume adjustment
The volume of the incoming call signal depends on your volume
setting. Eight volume levels can be set using the
Transmitting a call signal
Press the PUSH TO TALK button and press the
ringing tone will sound on the called unit for two seconds.
44
- Operation -
symbol
symbol will
and
buttons.
button once. A