Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
STANDARD ACCESSORIES
In addition to the main unit (1), the package contains the
accessories listed in the table below.
1 Charger (UC18YRSL) .......................... 1
2 Battery (BSL1430) ............................... 2
WM14DBL
3 Plastic case .......................................... 1
(2LSRK)
4 Battery cover ...................................... 1
Without charger, battery,
WM14DBL
plastic case and battery cover.
(NN)
1 Charger (UC18YRSL) .......................... 1
2 Battery (BSL1830) ............................... 2
WM18DBL
3 Plastic case .......................................... 1
(2LSRK)
4 Battery cover ...................................... 1
WM18DBL
Without charger, battery,
(NN)
plastic case and battery cover.
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES
(Sold separately)
1. Plus driver bit
Bit No.
No. 2
No. 3
2. Hexagonal socket
Part Name
5 mm Hexagonal socket
6 mm Hexagonal socket
5/16" Hexagonal socket
8 mm Hexagonal socket
10 mm Hexagonal socket
(small type)
10 mm Hexagonal socket
10 mm Hexagonal socket
1/2" Hexagonal long
socket
Engraved characters
9
Code No.
992671
992672
Engraved
L
B
Code No.
characters
8
65
8
996177
10
65
10
985329
12
65
12
996178
13
65
13
996179
14
65
14
996180
16
65
16
996181
17
65
17
996182
21
166 21
996197
3. Wood working drill: Code No. 959183
4. Drill chuck adapter set: Code No. 321823
Use drill bits available on the local market.
Optional accessories are subject to change without notice.
APPLICATION
Driving and removing of small screws, small bolts,
machine screws, wood screws, tapping screws, etc.
Drilling of various woods.
Drilling of various metals.
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION:
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the Electronic pulse driver, charge the
battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the
lines are visible, as shown in Figs. 3 and 4.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously
in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Publicité
Table des Matières
