Operation - Gardena 1889 Mode D'emploi

1. Remove the control unit
(B)
2. Place the battery in the battery compartment
(note the polarity + / –).
The connection LED is flashing.
3. Push the control unit
To connect the Water Control [ Fig. I3 ]:
The Water Control is fitted with a sleeve nut
G 1" (33.3 mm) thread. The adaptor supplied
the Water Control to be connected to taps with a (G 3/4")
thread (26.5 mm).
1. For a tap with a G 3/4" (26.5 mm) thread:
(8)
Screw the adaptor
(do not use pliers).

4. OPERATION

Manual operation by the Water Control [ Fig. F1 ]:
The valve can be opened or closed manually at any time.
Even a time-controlled open valve can be closed earlier
without changing the schedules.
If the Water Control is in "Sleep Mode", push the
Man. Button 2 times.
1. Push the Man. Button to open the valve manually
(or to close an open valve).
The LED Active Watering
2. Push the Man. Button to close the valve early.
1889-20.960.01.indb 17
(5) (6)
from the valve unit .
(7)
(5) (6)
back onto the valve unit
(9)
for taps with
(8) allows
onto the tap manually
(3) is lighting green for 10 sec.
2. Screw the sleeve nut
adaptor thread by hand (do not use pliers).
3. Screw the tap connector
To connect the Soil Moisture Sensor (optional)
.
[ Fig. I4 ]:
In addition to time-dependent control, it is also possible to
include soil moisture.
If the soil moisture is sufficient, irrigation is stopped or
skipped.
1. Place the Soil Moisture Sensor in the area to be irrigated.
2. Plug the connector
(5)
Control Unit .
The watering duration is according to the parameter of the
GARDENA Bluetooth
If a time controlled watering has been stopped manually,
this watering cannot start again.
If the valve has been opened manually and a programmed
start of a watering period overlaps the manual opening
period, the programmed starting time is suppressed.
(9)
of the Water Control onto the
(10) onto the Water Control.
(11)
into the sensor socket of the
App.
®
17
18.01.21 16:03