IKA IKAMAG RET control-visc C Mode D'emploi page 39

RMP_CONT_X X=1;4 Continuaton of ramp function (After prior RMP_PAUSE_X).
RMP_IN_X X=1;4 Reading the real segment number of ramp. With ramp not started: 0
RMP_INX_y X=1;4 Reading the accumulated value and the ramp segment duration of ramp segment y.
RMP_LOOP_RESET_X Ending of ramp loop.
X=1;4
RMP_LOOP_SET_X To work off the ramps in one loop.
X=1;4
RMP_OUT_X_yn X=1;4 Setting the accumulated value (n) and the ramp segment duration (hh:mm:ss) for ramp segment y.
hh:mm:ss
RMP_PAUSE_X X=1;4 Stopping the ramp function. Freezing of real rated value and real ramp segment time.
RMP_RESET_X Switching off ramp functions and deleting of all set ramp segments
RMP_START_X X=1;4 Starting the ramp function, beginning with ramp function No.1 (Only possible after prior START_X.
After RMP_STOP_X
RMP_STOP_X X=1;4 Switching off ramp function. Rated value = 0. (Ramp is maintained, that means, ramp can be restarted with
RMP_STARTX_X).
START_X X=1;2;4;5;7 Starting the instrument's (remote) function.
START_X X=16 Activation of the "watchdog" function. If no rated value is entered givenin the next 60 seconds, the heating is
(old function) switched off.
STATUS Display of status
STOP_X X=1;2;4;5;7 Switching off the instrument - (remote) function.
Variables set with OUT_SP_X are maintained. Contains the instruction RMP_STOP.
RETCV_0107
START_X is not necessary.
1S: mode of operation A
2S: mode of operation B
3S: mode of operation C
S0: manual operation without fault
S1: Automatic operation Start (without fault)
S2: Automatic operation Stop (without fault)
<0: error code: (-1)
- 1: error 1
- ... (see table)
-31: error 31
-83: wrong parity
-84: unknown instruction
-85: wrong instruction sequence
-86: invalid rated value
-87: not sufficient storage space
REMOTE
REMOTE
39