Cleaning And Maintenance; Cleaning; Troubleshooting; Conformity Declaration - bredent BF 2 Manuel D'utilisation Et D'entretien

6. Maintenance and cleaning

6.1 Cleaning

Only clean from outside using a lightly dampened cloth with the mains plug unplugged. Ensure that electronic
parts do not come into contact with moisture. Do not use any cleaning products containing solvents!
6.2 Maintenance
Do not clean the milling spindle with compressed air!
Clean the collet/chuck and mounter of the motor occasionally, depending on the degree of contamination
(see 5.8)

7. Troubleshooting

Fault
Machine switches off!
Milling spindle moves in a jerky
manner or performance reduces!
Milling spindle does not work!
Rotating tools can only be
clamped with difficulty and/or
move erratically!

8. Conformity declaration

bredent GmbH & Co. KG, Weissenhorner Str. 2, 89250 Senden, Germany, hereby declares that the milling
machine BF 2 has been developed in accordance with the relevant provisions, European guidelines and har-
monised standards in view of the design and construction of the product in the form brought to the market
by us. The conformity declaration can be requested if required.
20
30
31
29
Cause
Milling spindle is
overloaded
Electronic control
Network data and/or
connections do not match
Contaminated chuck!
bredent GmbH & Co. KG · Weissenhorner Str. 2 · 89250 Senden · Germany · T: +49 7309 872-22 · F: +49 7309 872-24
www.bredent.com · @: info@bredent.com
C
16
15
28
B
Troubleshooting
Restart!
Turn unit "off" and "on" again.
Contact bredent and send machine in
if necessary
- Compare data with type-plate
- Insert mains plug
- Correctly connect the cable of the
milling spindle
- Switch mains switch (22) to "on"
- Set knob (9) to the recommended
speed
See 5.8 (Caution)
Changing the collet/chuck