Preparatory Work - bredent BF 2 Manuel D'utilisation Et D'entretien

(30) Cable collection
(31) Driver (for motor drive)
(A) Allen key
(B) Collet key
(C) Counter wrench
(D) Drill shank ø 2.35 mm

5.3 Preparatory work

 Insert mains plug into the plug socket
 Switch mains switch ON/OFF (22) to "ON"
 Please note: Turn knob (9) to "zero" beforehand in order to regulate the speed - otherwise there is a risk
of injury! If the speed is not "zero" when the mains switch (22) is pressed, the micromotor will not
start. Turn speed controller to "zero" or press I / 0 (26). The micromotor starts.
 Secure model to the modelling table (18) and lock the insertion direction accordingly using the locking
lever (19).
 Secure the modelling table base (see arrow) from below through the opening of the milling table (11)
using the set screw (19), as required.
 Turn the lever (15) clockwise in order to open the milling spindle, insert the desired milling cutter and close
the lever again by turning it anticlockwise.
 Open the locking lever (13) and adjust the milling table to the correct working height using the scre driver
for the height adjustment (8) and close the locking lever.
18
4
25
bredent GmbH & Co. KG · Weissenhorner Str. 2 · 89250 Senden · Germany · T: +49 7309 872-22 · F: +49 7309 872-24
www.bredent.com · @: info@bredent.com
21
7
22
23
24