Troubleshooting; Spare Parts List Content - FMS Beaver V2 Manuel D'utilisation

Masquer les pouces Voir aussi pour Beaver V2:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

E
N
Trouble shooting
Problem
Aircraft will not respond to
the throttlebut responds to
other controls.
Extra propeller noise or
extra vibration.
Reduced flight time or
aircraft underpowered.
Control surface does not
move, or is slow to respond
to control inputs.
Controls reversed.
-Motor loses power
-Motor power pulses then
motor loses power.
LED on receiver flashes
slowly.

Spare parts list content

FMSPQ101-1
Fuselage
FMSPQ102-1
Main Wing Set
FMSPQ103-1
Horizontal Stabilizer
FMSPQ104-1
Vertical Stabilizer
FMSPQ105-1
Battery Hatch
FMSPQ106
Antenna Foam Cover
FMSPQ107-1
Cowl
FMSPQ108
Spinner
FMSPQ109-1
Engine
FMSPQ110-1
Vortex Generator
FMSPQ111-1
Airspeed Head Set
FMSPQ112
Antenna
FMSPQ113
Servo Cover
FMSPQ114-1
Main Landing Gear Set
FMSPQ115-1
Wing Strut Set
Visit our website: www.fmsmodel.com to see photo of this product. Enter the key word "ESC" in the search bar for the
stock ESC instruction manual.
Possible Cause
-ESC is not armed.
-Throttle channel is reversed.
-Damaged spinner, propeller,
motor or motor mount.
-Loose propeller and spinner parts.
-Propellor installed backwards.
-Flight battery charge is low.
-propeller installed backward.
-Flight battery damaged.
-Control surface, control horn,
linkage or servo damage.
-Wire damaged or connections
loose.
Channels are reversed in the
transmitter.
-Damage to motor, or battery.
-Loss of power to aircraft.
-ESC uses default soft Low Voltage
Cutoff(LVC).
Power loss to receiver.
-Lower throttle stick and throttle trim to lowest settings.
-Reverse throttle channel on transmitter.
-Replace damaged parts.
-Tighten parts for propeller adapter, propeller and spinner.
-Remove and install propeller correctly.
-Completely recharge flight battery.
-Replace flight battery and follow flight battery
instructions.
-Replace or repair damaged parts and adjust controls.
-Do a check of connections for loose wiring.
Do the control direction test and adjust controls for
aircraft and transmitter.
-Do a check of batteries, transmitter, receiver, ESC, motor
and wiring for damage(replace as needed).
-Land aircraft immediately and recharge flight battery.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
Linkage Rod
FMSPQ116
FMSPQ117
Screws Set
FMSPQ118
Pipe
FMSPQ119-1
Decal Sheet
FMSFLT002-1
Float Set
FMSFLT003-1
Float Strut Set
FMSPROP035
Propeller
FMSBM029
Motor Board
FMSDJ014
Motor Mount
FMSDZ005
Motor Shaft
FMSKV550
Brushless Motor
PRESC030
60A ESC
FMS17GAP
17g analog gear servo positive
FMSCON003
Multi Connector System
FMSRE015
Retract
16
Solution

Publicité

Table des Matières
loading

Table des Matières