Troubleshooting; Spare Parts List Content - FMS Yak-130 V2 Manuel D'utilisation

Trouble shooting
Problem
Aircraft will not respond to
the throttlebut responds to
other controls.
Extra propeller noise or
extra vibration.
Reduced flight time or
aircraft underpowered.
Control surface does not
move, or is slow to respond
to control inputs.
Controls reversed.
-Motor loses power
-Motor power pulses then
motor loses power.
LED on receiver flashes
slowly.

Spare parts list content

FMSPS101RED-1 Fuselage
FMSPS102RED Main wing set
FMSPS103RED Vertical stabilizer
FMSPS104RED Horizontal stabilizer
FMSPS105RED Cockpit
FMSPS106RED Cowl
FMSPS107 Linkage rod
FMSPS108 Screw set
FMSPS109-1 Front landing gear set
FMSPS109-2 Main landing gear set
FMSPS110-1 Main landing gear system
FMSPS111-1 Front landing gear system
FMSPS112 Pipe
FMSPS113RED Decal sheet
FMSPS114RED Fuel tanks
Visit our website: www.fmsmodel.com to see photo of this product. Enter the key word "ESC" in the search bar for the
stock ESC instruction manual.
Possible Cause
-ESC is not armed.
-Throttle channel is reversed.
-Damaged spinner, propeller,
motor or motor mount.
-Loose propeller and spinner parts.
-Propellor installed backwards.
-Flight battery charge is low.
-propeller installed backward.
-Flight battery damaged.
-Control surface, control horn,
linkage or servo damage.
-Wire damaged or connections
loose.
Channels are reversed in the
transmitter.
-Damage to motor, or battery.
-Loss of power to aircraft.
-ESC uses default soft Low Voltage
Cutoff(LVC).
Power loss to receiver.
-Lower throttle stick and throttle trim to lowest settings.
-Reverse throttle channel on transmitter.
-Replace damaged parts.
-Tighten parts for propeller adapter, propeller and spinner.
-Remove and install propeller correctly.
-Completely recharge flight battery.
-Replace flight battery and follow flight battery
instructions.
-Replace or repair damaged parts and adjust controls.
-Do a check of connections for loose wiring.
Do the control direction test and adjust controls for
aircraft and transmitter.
-Do a check of batteries, transmitter, receiver, ESC, motor
and wiring for damage(replace as needed).
-Land aircraft immediately and recharge flight battery.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
FMSDF12B70 Ducted fan (12-blade)
PRKV1850 2860-KV1850 motor
PRESC023 80A ESC
FMSSER9MGDP 9g digital metal gear servo positive
FMSSER9MGDR 9g digital metal gear servo reverse
FMSRE045 Electronic retract
FMSRE012 Electronic retract
11
Solution
E
N