Cleaning metal grease filters
The metal grease filters can be cleaned in hot detergent solution or
washed in the dishwasher. They should be cleaned every 2 months
• Remove grease filters.
use, or more frequently if use is particularly heavy.
• Open the visor by pulling it.
• Remove the filter, pushing the lever towards the back of the unit and
at the same time pulling downward.
• Wash the filter without bending it, leave it to dry thoroughly before
replacing (if the surface of the filter changes color over time, this will
have absolutely no effect on its efficiency).
• Replace, taking care to ensure that the handle faces forward.
• Screw the Frame into place
• Cleaning in dishwasher may dull the finish of the metal grease
filter.
• Close the visor.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable and cannot
be regenerated, and must be replaced approximately every 4
months of operation, or more frequently with heavy usage.
• Open the visor by pulling it.
• Remove the Filter, pushing it towards the back of the unit and at the same
time pulling downward.
• Remove the saturated Activated Charcoal Filters, as indicated (A).
• Fit the new Filters, as indicated (B).
EN
• Replace, taking care to ensure that the handle faces forwards.
• Close the visor.
Lighting unit
• Turn off electrical supply before replacing bulbs, and
make sure bulbs are cool to touch before proceeding.
• Remove the lamp at the base and turn slightly to the
left and the pull out from the connector and turn slightly
to the left.
• Replace the lamp with a new one of the same type,
making sure that you insert the two pins properly into
the housings on the lamp holder.
• Once the bulb pins are in place turn slightly to the right
to secure.
fixing pin lever.
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
A
B
Gu10 self-ballasted led
lamps – listed in ac-
cordance with
ul 1993/nmx-
j-578/1-ance/
csa c22.2 No.
1993
11