WAGNER ProSpray 26 Mode D'emploi page 29

©
Using unit on construction sites
Connection to the mains only through a special feed point,
e.g. through an error protection installation with INF ≤ 30
mA.
©
Setting up the unit
When working indoors:
Vapors containing solvents may not be allowed
to build up in the area of the device.
Setting up the unit on the side a way from the
sprayed object.
Danger
A minimum distance of 5 m between the unit
and spray gun is to be maintained.
When working outdoors:
Vapors containing solvents may not be allowed to blow to-
ward the unit.
Note the direction of the wind.
Set the unit up in such a way that vapors con-
taining solvents do not reach the unit and build
up there.
A minimum distance of 5 m between the unit
Danger
and spray gun is to be maintained.
©
Ventilation when spraying in rooms
Adequate ventilation must be guaranteed for the removal of the
solvent vapours.
©
Suction installations
These are to be set-up by the user of the unit according to
local regulations.
©
Earthing of the object
The object to be coated must be earthed.
©
Cleaning units with solvents
When cleaning the unit with solvents, the sol-
vent should never be sprayed or pumped back
into a container with a small opening (bung-
hole). An explosive gas/air mixture can be pro-
duced. The container must be earthed.
Danger
©
Cleaning the unit
Danger of short circuit through penetrating
water!
Never spray down the unit with high-pressure
or high-pressure steam cleaners.
Danger
ProSpray 26
GB
©
Work or repairs on the electrical
equipment
Only have this work carried out by a qualified electrician. No
liability will be taken for incorrect installation.
©
Working on electrical components
Remove the mains plug from the socket for all such works.
©
Setting-up on uneven surfaces
The front side of the unit must point downwards to prevent
sliding away.
Safety regulations
27