Parts Name Of Remote Controller - Toshiba RAS-M10SMUV-E Manuel Du Propriétaire

PARTS NAME OF REMOTE CONTROLLER

a START/STOP button
Push the button to start operation.
(A receiving beep is heard.)
Push the button again to stop operation.
(A receiving beep is heard.)
If no sound is heard from the receiver, push the button
again.
b Mode select button (MODE)
Push this button to select a mode.
Each time you push the button, a mode is selected in a
sequence.
A: Auto changeover control,
(for Heat pump model only),
model), and back to A. (A receiving beep is heard.)
c Temperature button (
...The set temperature can be raised to 30°C.
...The set temperature can be lowered to 17°C.
(A receiving beep is heard.)
d Fan speed button (FAN)
Push this button to select fan speed. When you select
AUTO, the fan speed is automatically adjusted according to
the room temperature. You can also manually select the
desired fan speed. There are five settings.
(LOW , LOW+
HIGH )
(A receiving beep is heard.)
e Auto louver button (SWING)
Push this button to swing the louver.
(A receiving beep is heard.)
Push the SWING button to stop the louver swinging.
(A receiving beep is heard.)
f Set louver button (FIX)
Push this button to adjust the air flow direction.
(A receiving beep is heard.)
g Off timer button (OFF)
Push this button to set the OFF timer.
h On timer button (ON)
Push this button to set the ON timer.
i Reserve button (SET)
Push this button to reserve time settings.
(A receiving beep is heard.)
j Cancel button (CLR)
Push this button to cancel ON timer and OFF timer.
(A receiving beep is heard.)
k High power button (Hi POWER)
Push this button to start the high power operation.
l Memory button (MEMO)
Push this button to store the settings.
Push the button again for 3 seconds or more to store the
setting indicated on the remote controller and
indicated.
(Refer to "MEMORY/PRESET OPERATION")
m ECO timer button (ECO)
Push this button to start the ECO timer (OFF timer)
operation. You can select the OFF timer duration.
There are four settings (1, 3, 5 or 9 hours).
n PRESET button
Push this button to operate the air conditioner according to
the settings memorized by the MEMO button.
EN
: Cool, : Dry,
: Fan only (For Cooling only
)
, MED , MED+ ,
o TIMER button
Use this button to change the clock, to set the On and Off
durations.
To forward the time, push the "TIMER
To set back the time, push the "TIMER
p Automatic operation button (AUTO)
Push this button to operate the air conditioner automatically.
(A receiving beep is heard.)
(Refer to "AUTOMATIC OPERATION")
: Heat
CAUTION
• When pushing the "FILTER" button.
The indoor unit does not operate and the receiver does
not sound a beep.
mark is
6
" button.
" button.