High Power Operation; Eco (1, 3, 5, 9H Off) Timer - Toshiba RAS-M10SMUV-E Manuel Du Propriétaire

HIGH POWER OPERATION

High power (Hi POWER)
• The High power (High power operation) mode automatically controls room temperature, operation mode so that the room is quickly
cooled in summer and warmed in winter. (Refer to page 17.)
Setting High power mode
a Hi POWER button
Push the Hi POWER button. The "Hi POWER" mark on the remote controller is
displayed.
Canceling High power mode
a Hi POWER button
Push the Hi POWER button again. The "Hi POWER" mark on the remote controller
goes out.
CAUTION
The High POWER mode cannot be activated in the DRY and FAN ONLY operation
or when the ON TIMER operation is reserved.

ECO (1, 3, 5, 9H OFF) TIMER

The air conditioner stops after operating for the set time (1, 3, 5 or 9 hours)
a ECO button
Push the ECO button (during operation).
• There is a short beep and the timer indicator comes on. The time at which the air
conditioner will stop is indicated on the remote controller display (1H: about 1 hour
after the current time).
• Push the button again while 1H is displayed (about 3 seconds) to change to the 3H
indicator, push again to change to the 5H indicator, and push again to change to the
9H indicator.
• After selecting the time you want, do not push any other buttons.
(When the 1H, 3H, etc. indicator goes off the timer is set.)
b CLR button
Push the CLR button to cancel the timer.
• The timer is cancelled but the air conditioner continues to operate.
• The 1, 3, 5 or 9H OFF timer operation is also cancelled if the OFF button is pushed
after setting.
INFORMATION INFORMATION
• When using the timer in combination with the ON timer, first set 1, 3, 5 or 9H OFF timer
and then set the ON timer.
• If the ECO button is pushed while the ON (OFF) timer has been set, the ON (OFF) timer
is canceled and only the 1, 3, 5 or 9H OFF timer is set.
EN
12