Parts Name Of Remote Controller - Toshiba RAV-SM562BT-E Manuel Du Propriétaire

PARTS NAME OF REMOTE CONTROLLER

Display section
In the display example, all indicators are displayed for the explanation.
In reality only, the selected contents are indicated.
• When turning on the main power switch and leak breaker at the first time,
flashes on the display part of the remote controller.
SETTING
• While this display is flashing, the model is being automatically confirmed.
Accordingly, wait for a while after
use the remote controller.
2
1
3
4
5
6
7
12
1
SETTING display
Displayed during setup of the timer etc.
2
Operation mode select display
The selected operation mode is displayed.
3
CHECK display
Displayed while the protective device works or a
trouble occurs.
4
Timer time display
Time of the timer with H mark is displayed. (When
a trouble occurs, the check code is displayed.)
5
Timer SET IN setup display
When pushing the Timer SET IN button, the
display of the timer is selected in order of
→ [OFF] repeat OFF timer →
[OFF]
→ No display.
[ON]
6
Filter display
If "FILTER " is displayed, clean the air filter.
7
TEST run display
Displayed during a test run.
8
Set up temperature display
The selected set up temp. is displayed.
9
Remote controller sensor display
Displayed while the sensor of the remote controller
is used.
display has disappeared, and then
SETTING
14 13
10
11
12
13
14
4
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
This remote controller can control
the operation of Max. 8 indoor units.
PRE-HEAT display
Displayed when the heating operation starts or
defrost operation is carried out.
While this indication is displayed, the indoor fan
stops or the mode enters in LOW.
No function display
Displayed if there is no function even if the
button is pushed.
Air volume select display
The selected air volume mode is displayed.
(AUTO) (HIGH)
(MED.) (LOW)
Unit Number display
Unit number of the indoor unit selected with the
unit select button or abnormal indication of the
indoor/outdoor unit.
Central control display
Displayed when the air conditioner is used
under the central control in combination with a
central control remote controller.
In case the remote controller is disabled by the
central control system,
The button operation is not accepted.
Even when you push ON/OFF, MODE, or TEMP .
button, the button operation is not accepted.
(Settings made by the remote controller vary
with the central control mode. For details, refer
to the Owner's Manual of the central control
remote controller.)
Display
section
ON / OFF
FAN MODE
Operation
section
SAVE VENT
SWING/FIX UNIT LOUVER
8
9
10
11
flashes.