Device Description; Initial Use - Beurer TL 41 Touch Mode D'emploi

• Power-on check item: check especially after reaching the expected operating hours whether light flashes,
dark areas/shadows and other abnormalities occur after power-on. If there is any abnormality, please
contact Customer Service.
• Power adapter is part of the medical equipment.
Repairs
IMPORTANT
• Do not open the device. Do not attempt to repair the device yourself. This can result in serious injury.
Failure to comply with this instruction will void the warranty.
• For repairs, please contact Customer Services or an authorised retailer.

6. Device description

1. ON/OFF sensor
2. Rear of the device
housing
3. Fluorescent screen
4. Stand
5. Mains part connection
6. Mains part

7. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact Customer Services or your supplier.
Setting up the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 20 cm and
45 cm between the user and the device. The daylight therapy lamp is most effective at this distance.
Note:
If the device has been in storage or recently transported, keep it for at least two hours at room temperature be-
fore using it.
Mains connection
IMPORTANT
To prevent possible damage to the device, the daylight therapy lamp must be used with the mains part descri-
bed here.
1. Insert the mains part into the mains part connector provided for this purpose on the rear of the daylight therapy
lamp and into a suitable mains socket. The mains part must only be connected to the mains voltage that is
specified on the type plate.
2. After using the daylight therapy lamp, unplug the mains part from the mains socket first and then disconnect it
from the daylight therapy lamp.
Note:
• Ensure that there is a mains socket close to the set-up area.
• Arrange the mains cable in such a way that no-one will trip over it.
3
2
1
14
6
5
4