7. Connection and Operating Elements
See picture.
1. Power switch
Turn on / off the mixer. The LED above will light up when the mixer is turned on.
The plug-in power unit still consumes a little power even when the device is switched off. Therefore remove the plug-in power unit
from the socket when you wish to disconnect the device from the mains completely.
2. Input selection switches / control knobs
Input selection switches
TRIM
HI
LOW
3. MASTER LEVEL (Master level meter)
Display the master amplifier output level.
4. MIC LEVEL (microphone level)
Adjust the microphone input signal level. Turn it in a clockwise direction to increase the level; turn it in an anti-clockwise direction in decrease
the level.
5. PFL LEVEL (pre-fade listen level)
Adjust the pre-fade listen output volume.
6. Channel fader
Adjust the volume level of channel 1 / channel 2.
7. PFL ASSIGN (pre-fade listen assignment)
Assign channel 1 / channel 2 to the pre-fade listen output.
8. TALK OVER (talk over)
When it is turned on, all sound level (except the microphone) will drop to 14 dB. Turn it off to restore to normal sound level.
9. CROSSFADER (cross fader)
Crossfade the sound between channel 1 and channel 2.
10. MIC (microphone input)
Connect the 6.3 mm plug of a microphone (not included) to the MIC socket.
11. PHONES (headphone jack)
Connect the 6.3 mm plug of a set of headphones (not included) to the PHONES socket. The PFL output can be heard from the pair of
headphones.
Select the input source between LINE and PHONO for each channel (1 and 2).
Adjust the input signal level. Turn it in a clockwise direction to increase the level; turn it in an anti-clockwise
direction to decrease the level.
Adjust the high-tone input signal level. Turn it in a clockwise direction to increase the level; turn it in an anti-
clockwise direction to decrease the level.
Adjust low-tone input signal level. Turn it in a clockwise direction to increase the level; turn it in an anti-clockwise
direction to decrease the level.
19