Installation Of The Monitor - Marmitek OBSERVER 25 Mode D'emploi

INSTALLATION OF THE MONITOR

1-4 Camera connections
Using the provided plug&play cable, connect the camera to the monitor as
shown in the diagram on the next page.
Plug the AC cord into an 230V outlet
Power the monitor by pressing the green power button
1. Camera 1 Terminal
Connect camera 1 cable to this terminal
2. Camera 2 Terminal
Connect camera 2 cable to this terminal.
3. Camera 3 Terminal
Connect camera 3 cable to this terminal.
4. Camera 4 Terminal
Connect camera 4 cable to this terminal.
AUDIO/VIDEO JACK CONNECTIONS.
Refer to the following connection method, for connecting a VCR or time lapse recorder
Monitor
Video OUT
Audio OUT
Video IN
Audio IN
NOTE : The cable for this connection is not supplied with the unit.
An "RCA" type cable is required.
8
VCR Terminal
Video IN
Audio IN
Video OUT
Audio OUT
C1 C2 C3 C4
1 2 3 4
AC power cord
MARMITEK