Monitor Unit; Installation - Marmitek WJ1512 Mode D'emploi

B. Monitor Unit
1-4 Camera connections
Using the provided cables, connect the camera to the monitor as shown in the diagram below.
POWER
AUDIO IN
1 2 3
AC IN PUT
VIDEO IN
1 2 3
ALARM OUT
CA1 CA2 CA3
NC N.O
CAMERA IN PUT
COM
1 2 3
AC power cord
Monitor with BNC cameras
The observation monitor may be installed with a standard BNC output security camera. Connect one end of the BNC
video cable to the output of the camera and the other end of the BNC video cable to the BNC camera input on the
rear of the observation monitor.
NOTE : Do not plug an observation camera and a BNC camera into a same camera port on the rear of the observation
monitor.
Example) Observation camera 1 (CA 1) - CA 1 port DIN terminal
BNC camera 1 (CA 1)
1512/1512Q
4
V C R SLAVE
4 IN OUT OUT
AUDIO
REMOTE
CA4
VIDEO
4

INSTALLATION

1. Camera 1 Terminal
Connect camera 1 cable to this terminal.
2. Camera 2 Terminal
Connect camera 2 cable to this terminal.
3. Camera 3 Terminal
Connect camera 3 cable to this terminal.
4. Camera 4 Terminal
Connect camera 4 cable to this terminal.
- CA 1 port BNC input (jack)
13