Technical Menu - Ferroli FORCE B Instructions D'utilisation, D'installation Et D'entretien

FORCE B
Press the contextual buttons 1 and 2 to increase the maximum power of all modules.
To deactivate the CASCADE TEST mode, press the contextual button 3.
The CASCADE TEST mode is disabled automatically in any case after 15 minutes.
After activating test mode, to exit the TEST make sure to deactivate the function, only by pressing the contex-
A
tual button "Stop Test".
DO NOT TURN OFF THE BOILER ELECTRICALLY DURING THE TEST.
If that happens, when the power is switched on again the system does not recognise deactivation of the TEST,
and starts working as though still in TEST mode and not as in a normal heating demand.

TECHNICAL MENU

ONLY QUALIFIED PERSONNEL CAN ACCESS THE SERVICE MENU AND MODIFY PARAMETERS.
The Technical Menu can only be accessed after entering the code 4 1 8. It is valid for 15 minutes.
Configuration - Parameters Menu
There are 16 parameters, indicated by the letter "b", which are not modifiable from Remote Timer Control.
Table 5- Parameters - Configuration
Parameter Description
b01 Gas type selection
b02 Boiler type selection
b03 System water pressure protection selection
b04 Fan max. frequency in DHW
b05 Fan max. frequency in heating
b06 Fan min. frequency in DHW/heating
b07 Fan min. Frequency Offset
b08 Variable output Relay operation selection
b09 Post-Ventilation
b10 Boiler room pre-ventilation
b11 Boiler room post-ventilation
b12 Fume sensor
b13 Not implemented
b14 Fumes Max Temperature
b15 Fan type selection
b16 Pump antiblock operation time
Notes
1. Parameters with more than one description vary their function and/or range in relation to the setting of the parameter given in brackets.
2. Parameters with more than one description are reset to the default value if the parameter given in brackets is modified.
EN
Range
Natural Gas/LPG
1-9
0=Pressure switch
1=Flow switch 1 sec.
2=Flow switch 3 sec.
3=Flow switch 5 sec.
4=Flow switch 10 sec.
5=Pressure transducer
0-255 Hz
0-255 Hz
0-255 Hz
0-255 Hz
0=Burner lit
1=Legionella pump
2=Boiler room ventilation
3=Motor-operated shutoff valve
0-120 seconds
1-15 minutes
1-15 minutes
OFF = Deactivated,
ON = Enabled
--
0-125°C
--
0-20 seconds
cod. 3541T170 - Rev. 00 - 09/2019
FORCE B FORCE B FORCE B
80 120 150
Natural Natural Natural
Gas Gas Gas
7 7 7
0 0 0
190 225 240
190 225 240
50 45 50
40 40 40
0 0 0
30 30 30
1 1 1
1 1 1
ON ON ON
-- -- --
110 110 110
-- -- --
5 5 5
157