Suction Nozzles; Before Initial Use; Unpacking The Items Supplied; Inserting / Removing The Handle Pole - Cleanmaxx T-110-80 Mode D'emploi

Suction Nozzles

CAUTION!
❐ Always switch off the vacuum cleaner before changing nozzles.

Before Initial Use

Unpacking the Items Supplied

CAUTION!
❐ Danger of suffocation! Keep the packaging material away from children and animals.
❐ Make sure that the device is not connected to the mains power before you attach or
detach the accessories.
Unpack all parts and check the items supplied for completeness (see the "Items Sup-
plied and Device Overview" chapter) and transport damage. If you fi nd any damage
to the components, do not use them (!), but contact our customer service department.

Inserting / Removing the Handle Pole

Notice: You can use the vacuum cleaner to clean fl oors with both the handle bar and
fl oor nozzle or as a hand-held vacuum cleaner with the tile nozzle to clean diffi cult to
reach areas.
Brush Vacuum Floor Nozzle
The fl oor nozzle is suitable for large, fl at fl oor coverings (car-
pet, tile, laminate etc.).
Crevice Nozzle
The crevice nozzle is suitable for cleaning all nooks and
crannies which you cannot reach with the other nozzle.
• Slide up the release button for the handle
• Insert the handle pole into the receiving socket on the
brush vacuum cleaner.
• Release the release button for the handle pole to fi x the
handle pole in place.
• When you want to detach the handle pole, switch up the
release button nach oben and pull the handle pole up and
out of the brush vacuum cleaner.
17
pole.