Danger Of Fire; Proper Use - Cleanmaxx T-110-80 Mode D'emploi

technical data for the device (see the "Technical Data" chapter). Only use suitable
extension cables whose technical data is the same as that of the device.
❐ Make sure that the connected mains cable does not present a trip hazard, does not
become squashed or bent and does not come into contact with hot surfaces.

Danger of Fire

❐ Do not use the device if highly fl ammable gases are present in the air.
❐ Do not cover the device during operation in order to prevent it from catching fi re.

Proper Use

❐ Use and store the device only in closed rooms. Do not operate it outdoors, in rooms
with high humidity or on hot surfaces.
❐ Always check the device and accessories for damage before putting them into ope-
ration. If the device, the cable, the plug or a fi lter shows visible signs of damage, the
device must not be used. Do not try to repair the device yourself or to replace any in-
dividual parts. In the event of any damage, contact our customer service department.
❐ Do not use the device if it has malfunctioned, sucked up liquids or objects or been
dropped. Have the device checked by a specialist.
❐ The device should only be used when it is fully and correctly assembled. The dust
container and the fi lters must be inserted and must not be damaged. If the dirt were
to get inside the device, this could damage the motor. The dust container must be
closed for it to be inserted correctly.
❐ Do not expose the device to extreme temperatures, wide temperature fl uctuations,
open fi re, direct sunlight, moisture or wet conditions.
❐ Do not drop the device or allow it to be knocked violently.
❐ Never place heavy objects on the device.
❐ Do not immerse the device in water or other liquids in order to avoid electric shocks.
Do not pour liquids into the dust container.
❐ Never touch the device, the cable or the plug with wet hands.
❐ Do not insert anything into the openings/nozzles of the device and make sure that
these do not become clogged.
❐ Never leave the device unattended when it is switched on or connected to the mains.
❐ Switch the device off and pull the mains plug out of the mains socket
– if you are not using the device,
– before you change accessories,
– if a fault or error occurs while the device is in operation,
– if liquids or foreign bodies have found their way into the device,
– before a thunderstorm,
– before you clean parts of the device and accessories.
❐ The device must be switched off when inserting or removing the mains plug.
❐ Always pull the plug and never the cable!
15