Télécharger Imprimer la page

Use; Before Machine Start-Up - Nilfisk ALTO SCRUBTEC 343E Manuel D'utilisation

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
WARNING
CAUTION
CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

Brush or pad-holder installation
NOTE
Use either the brush (42) or the pad-holder (43) according to the type of fl oor to be cleaned.
1.
Insert the positioning pin (24) and disengage the machine transport/parking device (23b).
2.
Lift the brush/pad-holder deck (10) by prying the handlebar (2).
3.
Place the brush (42) or the pad-holder (43) under the deck.
4.
Lower the deck (10) by using the handlebar (2).
5.
Connect the power supply cable (21) to the electrical mains.
6.
Engage the brush/pad-holder by pressing the brush/pad switch (52) for a few seconds.
If the procedure is diffi cult, manually turn the brush/pad-holder counter-clockwise (49).
Brush/pad application guide (suggestions only)
Types of brushes available
Concrete
Terrazzo fl oor
Ceramic tiles/quarrystones
General cleaning
Marble
Vinyl tiles
Rubber tiles
Rubber tiles
Polishing
Marble
Vinyl tiles
Squeegee installation
7.
Install the squeegee (11) and fasten it with the handwheels (12), then connect the vacuum hose (22) to the squeegee.
Solution tank fi lling
8.
Open the recovery water tank cover (41) and engage the support rod (59).
9.
Use the fi ller neck (35) to fi ll the tank (27) with a solution suitable for the work to be performed.
Do not fi ll the solution tank completely, leave a few centimetres from the edge.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40°C.
CAUTION!
Use only low-foam and non-fl ammable detergents, intended for automatic scrubber applications.
Adjustments
10.
Adjust the handlebar (2) with the knobs (3) to reach a comfortable position.
10
USER MANUAL
SCRUBTEC 343E
Midlite Grit 180
Midgrit 240
Prolite
Union Mix
909 6315 000(4)2009-11 A

Publicité

loading