DITEC DOD12 Manuel D'installation Et D'entretien page 22

OPERATING INSTRUCTION FOR INDUSTRIAL SECTIONAL DOOR AUTOMATIONS
RELEASE INSTRUCTION
Important: The overhead door may not be correctly
balanced. Release operations and manual door move-
ment must be performed with the motor stopped, by trained
personnel.
In case of malfunction or power failure, press the emergency
stop button [1] (COMPLETE STOP), unlock the motor by pulling
the cord or by rotating the DEB04 [2] handle and manually lift
the door [3].
If the DodSBV/SBO is used for opening or to close the door to
act on the crank (fig. 2).
Attention: Dod12B, Dod14B end Dod15B gear motor can be
manually actuated only by means of DodSBV or Dod SBO
device.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential
part of the product and must be supplied to the user.
Read them carefully as they contain important indications for
the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible
future user of the system.
This product must be used only for that which it has been
expressely designed.
Any other use is to be considered improper and therefore
dangerous.
The manufacturer cannot be held responsible for possible
damage caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving
mechanical parts.
Do not enter the field of action of the motorised door or gate
while in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger.
Do not lean against or hang on to the barrier when it is moving.
Do not allow children to play or stay within the field of action of
the motorised door or gate.
Keep remote control or any other control devices out of the
reach of children, in order to avoid possible involuntary activation
of the motorised door or gate.
In case of breack down or malfunctioning of the product,
disconnect from mains, do not attempt to repair or intervene
directly and contact only qualified personnel.
Failure to comply with the above may create a situation of
danger.
All cleaning, maintenance or repair work must be carried out by
qualified personnel.
In order to guarantee that the system works efficiently and
correctly it is indispensable to comply with the manufacturer's
indications thus having the periodic maintenance of the
motorised door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly. All installation,
maintenance and repair work must be documented and made
available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
1
S.p.A. BANFI,3 (VA)
VIA MONS. DITEC CARONNO ITAL 50314 P.LLA Y FAX.02/96
21042 TEL.02/96 TYPE 3911
YEAR DOOR Y MANUF 00000 0000 OF ACTURE
VOLTAGE SUPPL 000V
SERIAL 000000 NUMBER in Italy 00000
Made
3
Fig. 1
ON
OFF
Installer:
GB
DEB04 OPTIONAL
2
1
2
open
or close
Fig. 2
.
. BANFI S.p.A C ,3 (VA)
CARON MONS VIA DITE Y NO /96503 P.LLA 14
21042 /96391 FAX.02 1 ITAL
DOOR TEL.02 00000 TYPE TURE
MANUFAC OF
YEAR 0000 SUPPLY
VOLTAGE 000V NUMBER 0
SERIAL 00000 00000 Italy in
Made