Programming The Speed Controller; Programming Of Full Throttle And Neutral Positions - Reely ROAD Dragontail Notice D'emploi


10.

Programming the Speed Controller

a) Programming of Full Throttle and Neutral Positions
The speed controller can be switched to automatic or manual setting by the included programming card. Proceed as
follows:
• Switch off the speed controller ("OFF").
• Pull the speed controller plug from the receiver.
Remember the correct orientation and position of the plug in the receiver!
• Connect the speed controller plug to the programming card. Observe the right polarity of the plug: (black = minus /-).
• Connect the speed controller to the driving battery and switch on the speed controller ("ON").
The LEDs on the programming card are lit one after another and the motor emits a tone signal ("DO-RE-MI").
The sounds or bleeps are generated by the speed controller briefly activating the motor. Depending on
motor, the sounds may be very low.
Once all the data are read the LEDs light according to the existing programming and the motor emits 5 beeps.
• Using the programming card, you will now be able to switch between "neutral auto" and "manual":
"Neutral Auto": In the "Neutral Auto" position, the current position of the throttle/brake lever on the remote control
is taken as the neutral setting when the speed controller is switched on.
"Manual": In the "Manual" setting you can programme the speed controller's neutral and full acceleration setting for
forwards and reverse (when it is connected to the receiver) later when the speed controller is switched on for the first
time.
• After choosing "neutral auto" or "manual", press the "Enter" button. The settings made are transferred to the speed
controller and stored. The motor emits 5 beeps.
• Switch off the speed controller ("OFF").
• Disconnect the driving battery from the speed controller.
• Remove the speed controller from the programming card.
• Connect the speed controller to the receiver again.
Ensure correct connection, since the speed controller will not work otherwise.
• Switch on your transmitter (check battery condition!). Put the trim controls in centre position. Put the gas/braking
lever in neutral position and let go of it.
• Place the vehicle on an appropriate surface so that the drive can turn freely. Then insert the driving battery into the
vehicle and connect it to the speed controller.
50