Conrad GX106M Notice D'emploi page 39

For switching, the SMS or the e-mail contains the message text of the respective output with the appen-
dix =1 for activating or =0 for deactivating.
For activation, an SMS is therefore sent with the content
RELAY1 =1
and for deactivation an SMS with the content
RELAY1 =0
Example:
You call the output 3 „LAMP", because a garden lamp is connected to it. If you now send the SMS or e-
mail
LIGHT =1
the output SMS3 s switched.
With the SMS
LIGHT =0
the output SMS3 is deactivated again.
Note:
The text must always contain 8 characters. If the entered text is shorter, you have to
enter blanks (marked with stars here: LIGHT***=1).
If you click on „Sent by anyone", anyone sending this text as SMS or e-mail can activate/deactivate the
output. Or you select the receivers from your list in SMS and e-mail that may switch this output.
„Always switch with password" means that anyone who knows and sends the password can switch
this output. E.g. if your password is SECRET, anyone sending the SMS SECRET LIGHT =1 (with the
respective blanks SECRET**LIGHT***=1) can activate the output.
The module can return an automatically generated response to make sure that the output was switched.
The response is sent to the sender address.
38