After-Sales Service - Whirlpool ACM 795 Mode D'emploi

ERROR CODE
The hob switches off and after 30 seconds
emits an acoustic signal every 10 seconds.
C81, C82, C83
F42 or F43
F12, F21, F25, F36, F37, F40, F47, F56,
F60, F61, F62, F63, F64

AFTER-SALES SERVICE

Before contacting the After-sales Service:
1. See if you can solve the problem yourself with the help of the "Troubleshooting guide".
2. Switch the appliance off and then on again it to see if the problem has been eliminated.
If the problem persists after the above checks, contact the nearest After-Sales Service.
Always specify:
• a brief description of the fault;
• the product type and exact model;
• the Service number (the number after the word Service on the rating plate), located under the appliance (on the metal plate). The Service number is also given in
the warranty booklet;
• your full address;
• your telephone number.
If any repairs are required, contact an authorised After-Sales Service Centre (to ensure the use of original spare parts and correct repairs).
Spare parts are available for 10 years.
DESCRIPTION
Permanent pressure on the control
zone.
The control panel switches off because
of excessively high temperatures.
The connection voltage is wrong.
Call the After-sales Service and specify the error code.
F58,
POSSIBLE CAUSES
Water or kitchen utensils on the control
zone.
The internal temperature of electronic
parts is too high.
The sensor detects a discrepancy
between the appliance voltage and that
of the mains supply.
GB22
ERROR ELIMINATION
Clean the control zone.
Wait for the hob to cool down
before using it again.
Disconnect the hob from the mains
and check the electrical connection.