Whirlpool ACM 795 Mode D'emploi page 20

Table des Matières

Les langues disponibles

To ensure correct operation of the SIXTH SENSE function, we recommend that you:

use water only (at room temperature);

do not add salt, other ingredients or condiments until the water reaches

boiling point;

do not change the power setting of the cooking zone or remove or move the

pot;

do not use pressure cookers;

fill the pot to at least 1/3 full (min. 1 litre) and never to the brim (see table on

the right).

For optimum results, observe the following advice:

do not put the lid on the pot that is being used with the SIXTH SENSE function;

do not activate the SIXTH SENSE function if the zone is already hot (letter "H"

on the display).

When the water comes to the boil, the hob emits an acoustic signal. This signal is sounded three times at regular intervals. After the second signal, a minute minder is

automatically activated to keep track of boiling time. After the third signal, the hob automatically selects a lower power setting to keep the water simmering. From this

moment on, you can add any ingredients you like, set the timer and change the power setting. Changing the power setting or selecting the "hold" function overrides

the SIXTH SENSE function.

The function is deactivated when the "hold" function is selected.

The hob manages the SIXTH SENSE function and booster levels autonomously, therefore, in some cases, it may not be possible to activate the booster

with the SIXTH SENSE function already in use

The quality of the cookware may affect the performance of the SIXTH SENSE function.

Simmering Function

After bringing the food to the boil, select the simmering function: a power level designed to maintain a gentle simmer is automatically set.To deactivate the function

simply press OFF on the slide touchscreen.

Melting function

The melting function maintains a low and even temperature in the cooking zone. After positioning the pot/accessory on the chosen cooking zone, switch on the hob

and select the cooking zone. Press the key

touchscreen.

Flexi cook

This function allows you to use the cooking area as two separate cooking zones or as an extra-large single zone.

It is perfect for oval, rectangular and elongated pans (with maximum base dimensions of 38x18 cm) or more than one standard pan. In order to activate the flexicook

function, switch on the hob and press the button

Flexi cook is activated.

To change the power level, move your finger along the slide touchscreen: the number inside the circle will change with just a quick slide of the finger from a minimum

of 1 to a maximum of 9. To deactivate the flexible zone function, press the key

off, press OFF

The message "no pot"

induction hob). This message remains active for 60 seconds: in this time you can add or slide pots within the flexicook area as you prefer.

After 60 seconds if no pan is placed on the zone, the system stops "searching" pots on that zone, the symbol

zone is disabled.

To reactivate the Flexicook function on both heaters, press the button

The Flexi cook function is also able to detect when a pot is moved from one zone to the other one within the flexi cook area keeping the same power level of the zone

where the pan originally was placed (see the example in the figure below: if the pot is moved from the front heater to the rear heater, the power level will be shown

on the display corresponding to the zone where the pot is placed).

: "A" appears on the display and the indicator light turns on. To deactivate the function, simply press OFF on the slide

: the two cooking zone displays show level "5"; both dots next to the level number are lit, indicating that the

will appear on the display of the zone that is not able to detect any pot (because of missing pot, or misplaced or not suitable for

Cooking zone

diameter

18 cm

: the cooking zones revert to operating singly again. To switch the cooking zone

GB20

Pan base diameter for

Maximum amount

SIXTH SENSE function