Control Panel Description; Switching The Hob On/Off - Whirlpool ACM 795 Mode D'emploi

Wires
230 V ~ +
230-240 V ~ +
230 V 3 ~ +
400 V 3N ~ +
400 V 2N ~ +
A B
Connect the yellow/green earth wire to the terminal with the symbol
This wire must be longer than the other wires.
1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).
2. Strip approx. 70 mm of sheath from the power supply cable.
3. Strip approx. 10mm of sheath from the conductors. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the
connection diagram located near it.
4. Secure the power cable with the cable clamp.
5. Close the cover (C) and screw it on the terminal block with the previously removed screw.
Each time the power is connected, the hob performs an automatic check for a few seconds.
Connect the appliance to the power supply by means of a multipole switch with minimum contact gap of 3mm.
INSTRUCTIONS FOR USE

Control Panel Description

The panel has touch controls: to use them, just press the corresponding symbol (a light touch is sufficient).
Hob ON/OFF
To select one of the automatic functions
First use / after a power failure
After connecting the hob to the electrical power supply, the control panel is locked (the indicator light above the key is ON).
To unlock the control panel, press and hold the

Switching the hob On/Off

To switch the hob on, press and hold the
the cooking zones.
To switch off, press the same button until the hob switches off. All the cooking zones are deactivated
i
The hob automatically switches off if no function is selected within 10 seconds of switching on.
Number x size
2
3 x 4 mm
2
3 X 4 mm (Australia only)
2
4 x 1.5 mm
2
5 x 1.5 mm
2
4 x 1.5 mm
C
To select and activate the cooking zones
key for 3 seconds. The indicator light switches off and the hob can be used normally.
key for approx. 2 seconds: the indicator light above the key switches on and dashes appear inside the circles indicating
400 V 3N ~
400 V 2N ~
.
Slide touchscreen
GB18
230-240 V ~ (Australia only)
230 V ~
230 V ~ (UK only)
230 V 3 ~ (Belgium only) 400 V 2N ~ (NL only)
To select the Flexi Cook function
To lock the control panel
To set the minute
counter
To enable the hold
function