Location Of The Skimo Split Unit; Electrical Connection - SNDC ECOCLIM SKIMO SPLIT 12V Notice De Montage, De Service Et De Maintenance

Location of the SKIMO SPLIT unit

Fix the SKIMO SPLIT unit to the wall by means of the supplied stainless screws :
•
4 HM8-20
•
8 flats M8
•
4 slices EPDM 8.5x20mm
•
4 nuts HM8.
Location of the vertical evaporator
Fix the vertical evaporator unit to the wall by means of the supplied stainless screws
•
4 HM6-25,
•
8 flats M6,
•
4 nuts HM6.

Electrical connection

The installer must make sure that the cables are insulated and protected from any risk of deterioration or tear-up (from
branches for example) and that they do not present any risk for people or appliances.
The passage of electric cables will be made on the side of the unit.
Caution
Once the cables laid out, connect them as
follows to the SKIMO unit electrical motor:
Once the cables laid out, connect them as follows to the SKIMO unit electrical motor:
1. Take the 2 nuts of the motor (+) terminal
off. Insert the red cable through the rubber
cover.
4. Connect the cables to the battery or to the alternator. The fuse housing with its fuse (100Amps for 12Volts, 50 Amps for 24Volts)
must be fitted on the red positive cable less than 15cm away from the crimp terminal connected to the (+) terminal of the battery or
of the alternator.
SNDC – 274 chemin des Agriès 31860 Labarthe-sur-Lèze – France
Tél : +33 (0)5 34 480 480 - Mail :
EN
Access of the 4 fastening Accès aux 4 points de f xation
unit
Caution
Passage des
câbles
SKIMO SPLIT
Paroi
2. Screw the nuts back on onto the red
cable and red wires crimp terminals and
the washer
– www.sndc.net
sndc@sndc.fr
Rondelle EPDM
EPDM
slice
Nut HM8
Écrou frein HM8
Rondelles
Flat M8
plates M8
:
Put the rubber cover back into place.
3.
Repeat 1 and 2 on the motor (-) terminal
with the ground black cable and wires.
Inside of the
INTÉRIEUR
SKIMO SPLIT
SKIMO SPLIT
Screw HM8-20
Vis HM8-20
Wall
Paroi du véhicule
vehicle
INTÉRIEUR
CABINE
p.22